Question Locked

Running out of ip addresses.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello

We are running out of ip addresses in our subnet 10.164.231.xx 255.255.255.0.

What is the best solution to get more ip's since our network is growing very fast? We have other sites with the following subnets but they are still long way to go until depletion. they use 10.164.232.xx 255.255.255.0 and 10.164.234.xx 255.255.255.0. How can I subnet our network without affecting the other sites or should we add another subnet to our network?

We use Windows Server 2003 with Active Directory.

Please, all help will be appreciated.

Thanks,

5 replies

by fregeus

Hi

You have two possibilities. You can change your subnet 10.164.231.xx 255.255.255.0 to a 10.164.230.xx 255.255.254.0.
That will give you the range of addresses from 10.164.230.1 to 10.164.231.254. That way, the devices that have addresses now can keep them, you just need to change their subnet mask, and it give you 254 more addresses. If you think you need more, you can also do 10.164.228.xx 255.255.252.0 which will give you about 762 extra addresses.

Or, you can add another subnet.

If you pick the first option, you will need to change your routers config to reflect the new subnet mask.

TCB

by bonillam

Tai Chi Bear

thanks for your reply. That sounds like a good plan. Do I have to change the ip address on the router to 10.164.230.x 255.255.254.0? or only the subnet?

Thanks again.

by fregeus

Can keep its address, but you will need to change the subnet mask. It all depends on your standards. I like to put the router on the .1 of the first available address. That would cause me to change the IP of the router. But it would also require me to change the DHCP and all static devices. If you keep the same address and just change the subnet mask, then you have less changes to do on your DHCP and static devices.

TCB

by bonillam

Tai

That's what I'm going to do. Keep the router as is now and change only the subnet mask. Thanks for your help!

This discussion is closed to new replies.