Question Locked

Running out of IP's on a flat 192.* network

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running out of IP's on a small school Win2003 network. I have my high school on
192.168.2.* (all PC's) and most of my elementary on 192.168.2.* with a real small 192.168.1.* MAC network with server and <20 machines. We are this year transferring over to all PC's and will be going over our .1 to .253 amount allowed. I wondered if a simple fix for this would be to add a scope on the DHCP server of 192.268.1.1 to 192.168.1.253 with exclusions?
Are there any problems in doing this, now or in the future. I realize that VLANS would do the job better but I am not savvy enough yet to setup a network like this (mostly self-taught).

Brent
careyb@osdco.com

4 replies

by retro77

You need to move into the 10.X.X.X networks eventually. Its another, non internet routable network.

In the mean time, get the devices that are statically assigned on the 192.168.1.X network all to either the beginning or the end of the network. Then in your DHCP scope, you can make a scope like 192.168.1.100 - 192.168.1.254.

by 1bn0

I've found this reference very usefull.

http://articles.techrepublic.com.com/5100-1035_11-6089187.html

EXCERPT:

The following blocks of IP addresses are allocated for private networks:
10.0.0.0/8 (10.0.0.0 to 10.255.255.255)
172.16.0.0/12 (172.16.0.0 to 172.31.255.255)
192.168.0.0/16 (192.168.0.0 to 192.168.255.255)
169.254.0.0/16 (169.254.0.0 to 169.254.255.255)*

*Note that 169.254.0.0/16 is a block of private IP addresses used for random self IP assignment where DHCP servers are not available.

10.0.0.0/8 is normally used for larger networks, since there are approximately 16.8 million IP addresses available within that block. They chop it up into lots of smaller groups of subnets for each geographic location, which are then subdivided into even smaller subnets. Smaller companies typically use the 172.16.0.0/12 range, chopped up into smaller subnets, although there's no reason they can't use 10.0.0.0/8 if they want to. Home networks typically use a /24 subnet within the 192.168.0.0/16 subnet.

You might want to step up to the 172.16.0.0 range instead of all the way to 10.0.0.0.

Either way, select a subnet under one of those scopes that will accomodate the project growth. You mention one high school and one elementary school. Each of the ranges will allow a subnet with more than 255 addresses. making each a seperate subnet within the same private ip range makes them different segments of the same network.

I'm not an expert but I don't see one giving you better information.

Plan for more than you have.

Refer to the article as a basic primer.
Look at a bigger picture.

by sgt_shultz

is anybody in here?
your post does not make sense to me. if you are not joking, perhaps check out
www.howtosubnet.com. Go equipped with how many networks and how many hosts (pc's) you'll need to accomodate your setup. That'll give you a network address and subnet mask. or check out 'superscope' at support.microsoft.com and see if that is what you are looking for...

This discussion is closed to new replies.