Question Locked

Running single boot drive with raid 5 data drive (failed raid 5)

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm working to recover data from a failed raid 5 and think my problem is coming down to running a single bootable drive together with the raid 5 volume.

Setup:
Mobo - Asus Maximus Extreme
3x WD Velociraptors using Intel Matrix for 2 raid volumes: Bootable Raid 0, Raid 5.
A new bootable single drive.

One drive failed which kills my bootable raid 0, but the data on my raid 5 should still be readable. So I grab a fresh drive and install vista, hoping to be able to see my raid 5 volume.

The problem is I have to change my bios "Configure SATA as" from RAID to IDE in order for it to see the new single drive. Of course this prevents Intel Matrix Storage Manager from setting up the RAID 5.

Is there no way to run a single bootable drive along side an Intel Matrix Storage Manager raid?

Thanks,
John

2 replies

by oh smeg

In this case No I don't think that there is a way out of this problem.

As things stand when you change the way that the BIOS sees the HDD's from the RAID to seeing them as IDE Drives the basic parameters are changed as to how the Hardware Addresses the HDD's as they are all seen as Individual Drives and not as members of a RAID Array.

About the only possible way out of this is to install the OS without the RAID 5 Drives connected and then try to establish the RAID Array inside Vista after it is loaded but I honestly do not think that that will work.

Ideally you should be able to recover from your Backup and just work with what you have got or attempt to Rebuild the Primary RAID 0 Array then mount the RAID 5 Array latter.

That is of course if I am reading your Question the way that you mean. ;)

Col

This discussion is closed to new replies.