Question Locked

Sata ports not available in bios?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am upgrading my younger brothers Dell desktop and installing a second SATA hard drive.

On the motherboard there are 4 physical sata ports 0,1,2 & 3.

Port 0 is connected to the HD that came with the desktop (boots xp from)

Port 1 is the DVD writer and 2 & 3 are free.

I have connected the new Maxtor 250gb HD to both ports (2&3) and tried to get windows to recognise them with no luck.

In the Bios ports 2 & 3 are "not recognised in this chassis" with or without anything plugged in but ports 4 & 5 are available even though they don't physically exist on the motherboard?!?!?

The Motherboard recognises the new Maxtor HD if I remove the DVD writer and connect it to port 1, but then I can't use the DVD writer!

If I turn ports 4 & 5 (which don't physically exist) on in Bios the system won't boot because "there are no drives connected to these ports".

Anyone got any ideas I'm tearing my hair out! Why can't the bios see the two physical ports and why is it detecting two that aren't there?

3 replies

by alfa11

You should read the manual, maybe the ports 3 & 4 are for setting up a RAID configuration.

by vic043

I had almost exactly the same problem and stumbled across your post while looking for a solution.
I don't have the ports 4 and 5, but do have ports 0, 1, 2 and 3. The Dell came with the new HDD attached to Port 0, and the new DVD drive attached to Port 1. I wanted to attach my old secondary HDD and DVD drives to the available SATA Ports 2 and 3. I bought PATA:SATA converters, new power adaptors and SATA cables. Connected it all up and it wouldn't recognise the newly attached hardware. I swapped the second HDD from Port 2 to Port 1, and attached the new DVD drive to Port 2. This resulted in both the HDDs being recognised but neither of the DVDs; therefore a problem with Ports 2 and 3.
I tried a number of BIOS suggestions from the web, but I through trial (and a bit of error) I seemed to have fixed it.
Go into your BIOS settings:
Advanced/Integrated Peripherals/Serial-ATA Configuration and change the SATA Controller option from SATA-1 to SATA-1+2
I'm not an IT expert by any means, so someone may tell me that this is absolutely NOT what to do, but it looks to have worked for me.
Hope this helps,
Vic

This discussion is closed to new replies.