Question Locked

SBS 2003 RAID re-setup

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I purchased a new server box off Tiger Direct about a month back, and had to go through some pretty strenuous setup issues. Primarily, the existing network that was to be placed on the new server was royally botched (static IP's forced through DHCP, a firewall that couldn't handle as many IP's as we had, no backups, and an OS partition that was gorged from being botched into a Software RAID configuration, etc...)
Upon setting up the new network, we had some hardware issues, and it never prompted for an F6 disk for RAID setup. As a result, I just assumed there would be a point between OS partitioning and final setup that would stripe the HDDs. Woops.
So, is there any way to install and run my Hardware RAID capabilities short of reinstalling the server?
Thanks,
Alex.

4 replies

by cg it

if you have hardware RAID, then you need to setup the RAID Array FIRST, before you install the O/S.

Windows Setup "must" provide you with the F6 to install the RAID array drivers or it won't see the RAID array therefore not install itself into the RAID partition you want [assuming a RAID5 setup].

Also, depending upon the mainboard bios, you might have to configure the boot sequence to boot SCSI for Windows to find the bootable array. New boards withon onboard RAID controllers often provide the array in the boot sequnce option. Some mainboards don't.

HP and Dell both have software utilitiy CDs or DVDs that will handle the entire setup from setting up RAID 0/1/5, formatting discs and installing the O/S. I recommend using those instead of manually trying to create arrays, format the discs and install the O/S.

This discussion is closed to new replies.