10 replies
by trish44 Accepted solution
by robo_dev Accepted solution
On some laptops with wimpy usb ports, I've had to plug the power half of USB splitter cables into separate USB power supply or powered USB hub to get enough power.
It wont hurt anything to plug the power-side of the USB splitter into your machine, and plug the data side into your husbands machine...this could verify that it's a power problem.
by oh smeg Accepted solution
With the USB Y Cable that was supplied with this device the One closest to the HDD is a Power & Data Plug while other the USB Plug is a Power Plug Only.
If you are not plugging in the Power & Data Cable Windows will not see any new device as there is none there. There is only the HDD consuming Power but as there is no Data Connection to the HDD it can not be identified or seen. You need to correctly connect to the Desktop computer.
Though with this type of M'Board I would suggest using a Powered USB Hub as apposed to installing a USB Card. You can add up to 128 USB Devices to any one USB Port with the use of Powered USB Hubs. So unless you need the extra USB Ports for the USB Devices that you have it is better to get the power for them from outside the computer instead of attempting to draw it through the M'Board.
Col
Col
by trish44 Accepted solution
by oh smeg Accepted solution
As apposed to just a USB Hub. the type you need has it's own Plug Pack and supplies 550 Milliamps to each USB Port.
If you use a unpowered USB Hub it will still be drawing all the power throught 1 USB port on the Plug In Card and through the computer so you would be no better off.
Col
by oh smeg Accepted solution
Are both OS's the same on the different computers.
It is just possible that a HDD formatted on XP may not be seen under Vista. If that is the case here you will need to format the HDD on the Vista Computer and then copy the stuff to it from the XP Computer.
If you need to format the HDD under Vista Open the Drive Management Window and right click on the USB Drive there and select the Format Option.
Col
by trish44 Accepted solution
by trish44 Accepted solution
by dr dij Accepted solution
On any USB HD drive, if you power off the drive without doing the shutdown of the drive or your PC, or if the drive loses power during power fluctuation or outage, it will corrupt the drive and/or free space table.
If this happens, copy stuff off it if you need to and can, reformat it and put it back on, and get a mini-ups for your computer and the drive.
I have two older silver seagate usb drives, 300 gigs each and love them. They are rock solid and I backup critical directories to this and store them off site.
But I bought a 750g freeagent drive but had to return it for the following reasons:
it got very hot on the bottom. I was getting worried about the wood shelf I had it on.
The touch capacitance button turned it ON ok but no matter how long I held it would not go off. (even with computer shut down before this)
If I left it connected during boot on my w2k system would freeze the whole computer BEFORE IT BOOTED.
I have a bios password AND I have the computer set to boot off ONLY HD and it would not even get to this! Very bizarre! Yet if I waited till booted, then plugged it in, I could see my files I had copied over there.
Seagate tech just blew off my request to figure out these problems so back it went to Fry's.
It has some kind of system software on it which must be causing these problems. Other hard disks don't have mystery software on them.
by oh smeg Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending