Discussion Locked

Secondary Domain Contoller cant network

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

...hi!
...Recently got newer Mecer Celeron PCs & WinY2K Advanced Server. I upgraded from WinNT Server it took about 4 hours to Setup, the system crashed after restarting & after the 3rd restsrt it seemed OK. Then the mouse pointer started flickering & is always jumping across the screen. I decided to stick to NT Server, so I cloned the original HDDrive onto the bigger HDDrive & put it into a new PC. Now, the Secondary Domain Controller cannot see any computers on the network, yet the PDC can fully see and access it. I tried synchronising but couldnt. The error message said that it the dependancy service or group failed to start.
...please help!!
...SAFE!!!

2 replies

by aclopez5

Questions:
1. Which domain controller where you trying to upgrade to W2k? PDC or BDC
2. How did you restore the system you tried to upgrade?
3. The message about a dependancy service failing to start is an indication that a different service failed to start. In other words, you try to start ServiceA and ServiceA depends on ServiceB. ServiceB won't start, so you get the dependancy error when you try to start ServiceA. You need to figure out what service ServiceB is.

by bklein

You said:
"so I cloned the original HDDrive onto the bigger HDDrive & put it into a new PC."

Sorry, but that simply won't fly with NT4. You were very lucky to have it be able to apply the existing NIC driver and use the new NIC. The OS probably has no idea how to address the new motherboard/chipset, therefore you're running into hardware dependencies. The I\Os and IRQs can't possibly be the same on both machines if they're not identical.

If the server's only job is that of a BDC, just format and re-install the OS (without IIS) with SP6a and all the correct drivers for your new hardware.

Good luck!

This discussion is closed to new replies.