Question Locked

Server Setup

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a dell poweredge server with to hdd. what is the best raid array to see both hdd? I've set it to Raid 0.

5 replies

by hal 9000

You can set it up for Performance and use a Stripped RAID or Reliability and use a Mirrored RAID.

With the Stripped Array you get best performance but not any reliability so when a drive fails you loose everything as only half the required data is present on the one remaining drive. If you Mirror the drives you get better reliability but slower performance so when a drive fails all you need do is replace the dead drive and rebuild the RAID.

A better explanation of different RAID setup is here

http://tinyurl.com/336zd

Col

by obionekenobi

What type of things will the server be used for? If you need redundancy than I would not use RAID 0 because if one of the drives fails than your array is gone and all your data will be lost. RAID 1 will create a mirror image of your disks if you need redundancy this is the way to go. If you just want performance RAID than go with RAID 0. If you want to buy a few more drive than you could look into other RAID setups like RAID 5 etc.

by tdenmark1

The server will be running a billing database and store common daily spreadsheet and word document files. With the raid set to 1 will this better?

by hal 9000

So that when a drive fails you will be able to rebuild the Array by just replacing the dead drive and running the rebuild wizard which effectively just formats & copies from the other HDD.

For [b]Mission Critical[/b] work I always use RAID 1 as the only option that is usable for business. I only use RAID 0 where speed is required and then I keep cloned drives available just in case of the worst happening.

Col

This discussion is closed to new replies.