Question Locked

Set SATA drive as removable in Windows 2003

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

A Windows 2003 server I support has an after-market SATA controller connecting a removable drive bay. 400GB drives are used for backup.

How do I make the server see these drives as removable so I can swap them without restarting the server?

2 replies

by bart777

If the controller supportss hot swap devices then it shouldn't be a problem. However that will requiure the RAID to be configured by the card, not windows.

I would check with the manufacturer on the card and if it supports hot swap. You maay only need to flash the firmware on the device.

Best of luck

This discussion is closed to new replies.