8 replies
by cloudsevn Accepted solution
by nimmo Accepted solution
Take a look at these KB's
by hal 9000 Accepted solution
by oh smeg Accepted solution
Connect to the Internet. With Wire or Wirelessly?
If it one or the other the above will be of assistance to you.
But if the PC is connected with Wire and the NB Wireless you need to enter the Routers Setup and bridge the Wired and Wireless Networks so that they see and can communicate with each other.
As well as doing the above after you have set the Router to allow the 2 LAN's to communicate with each other.
Col.
by cloudsevn Accepted solution
by hal 9000 Accepted solution
by oh smeg Accepted solution
And look up the HTTP address for the Router. Open your Web Browser and enter the HTTP Address then enter when the Browser Interface opens insert the Routers User Name &
Password.
From there you'll need to look at the Manual as different makes/models have different ways of doing this.
Might pay you to check the Firmware while your at it as well and update to the newest Firmware before doing this.
Col
by cloudsevn Accepted solution
Thank you all for your time and help. After some more reading and asking around i figured everything was set up good, I just didn't do the drive mapping right. After I typed in
\\132.168.0.xxx\
in the run command everything worked fine from both PC's. But before that whenever I tried to go in the "view all workgroup computers" I just didn't see any and it even said that MSHOME is unavailable. But now it work fine. So thanks again...
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending