Question Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am attempting to share internet between two windows-based PCs. I have a Netgear FS105 Fast Ethernet 5-Port Switch. I have only ever networked using a router. The internet connection is a adsl dhcp provider. Whe I plug everything into the correct ports, I get an IP conflict on one of the computers. One works. One doesn't. I have rebooted the modem and the router. Restarted both the computers. Tried different ports. It says on the box that I need network management software. I didn't know what I should do. Thanks!
4 replies
by jaz_e24 Accepted solution
Clarifications
by w2ktechman Accepted solution
If not, then manually configure the IP addresses.
It may also be a problem without a router if your ISP only gives you 1 DHCP address (or static).
by jmgarvin Accepted solution
How is your subnet setup? Does your switch support DHCP?
by cg it Accepted solution
So, you run the ICS wizard on one of them. Then that computer will act as the router so that the other computer will be able to access the internet.
my opinion, get a router. Less of a problem
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies