Discussion Locked

simulation of RJ45 port

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how to simulate a RJ45 port to act as serial port any software available. please help me on this

2 replies

by nicknielsen

Communications through an RJ-45 port is determined by the controller connected to that port (usually a network controller). No software can change this.

If you want to connect a serial device to your local computer and do not have an available serial port, use a USB-to-serial adapter cable (http://tinyurl.com/6zry84)

If you are trying to connect remote serial devices to your computer over Cat 5, you will need physical adapters (http://tinyurl.com/5cruac).

If you are trying to connect serial devices to an IP network, you can use an interface such as the ESP-8 (http://tinyurl.com/64fqcy). You can connect up to 8 serial devices using RJ-45 connectors and Cat 5 cable. You will still need adapters to convert from RJ-45 to DB-9 or DB-25 at the equipment serial input.

This discussion is closed to new replies.