Discussion Locked

Slow performnce with NT4 and Netware 411

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Orignal Netware 4.11 LAN has been extended by addition of several NTv4 servers. Primary logon/authentication is now handled by NT first, which also provides a gateway to Netware-based apps and data.
Logon now takes ages (1min+), browsing folders (some large, with 1-3000 files) also takes similarly excessive time to respond. PCs occasionally drop off the LAN (10Mb/s CAT5 ethernet, IPX & TCP). All 100 w/s run Win95 and Off-95/97.
Has anyone experience of this problem - or any suggestions of cause/solution?
(All LAN hardware components and traffic has been checked OK)
Cheers.

8 replies

by kloran-[thrawn34

How was the log-on handled before? Is it imperitive that you use NT? If not, I would just go back to straight Netware. Your problem might be you are running 2 different kinds of OS' and that always slows things down becuase the cpu is being split between the 2.

What kind of hardware do these servers have? I would check to see if they close to the requirements for NT and Netware. If possible, double the memory and CPU speed. Run dual if you can. (I dont recall if NT can support this, I know 2k does)

Most of this depends on how much you have availible to spend.

I havent heard of any blazing fast NT/Netware set ups before. Even the High Schools old NT network was a bear, and it was just NT.

by baziite

Use performance monitor on the authentication server to see the CPU usage if the CPU usage constantly stays higher than 80% then consider moving the gateway service for netware or any other CPU intensive services away from the authentication server and on to another server whoose CPU usage is low . Also check if replication service is running on the authentication server ..you can always schedule your replications to a time when authentication trafic is low ( eg after hrs )

I hope it helps
Much Luck

by baziite

You can also fine tune the replication parameters so that repilation doesn't occur often . This is only if you are running the replication service

by grbeckmeyer

Sounds like you are using Gateway service for Netware on your NT server. This will be a bottleneck as the NT server will act as a 'proxy' to the Netware server. All clients accessing Netware resources will be doing so via the NT server, so if you have more than a handful of workstations this could slow things down greatly. Also, make sure no computers are running netbeui as it is a very chatty protocol. One last thing, there is a DOS limitation that can cause problems with directories containing a large number of files, though this article mentions 15,000. Check this Novell link for brief explanation- http://support.novell.com/cgi-bin/search/searchtid.cgi?/10021744.htm
remember to remove any spaces in the URL

This discussion is closed to new replies.