Discussion Locked

SOYO K7VEM PRO MOTHERBOARD

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
athlon 1700+processor.128M ram.fsb266,12g hd,cdrw,microtech scan 4,hp 880 printer,windows 98 2nd ed. (bought as a barebones system from tigerdirect. mouse freezing(appears to be processing) then continues on after about 15 sec. brand new board&processor with fan's. system temp@95 chip temp@105. heat paste on cpu already.

9 replies

by hparks

already flashed bios to latest from soyo. original problem was shutting down at random.

by deadly ernest

Suggest you try for updated drivers for the mouse
as a first action. Also check with motherboard book if those operating temps are within tolerance, they seem a bit high but I am used to working with centigrade and not sure of my conversion factors.

by hparks

will recheck the temp again with soyo, "just" to make sure. I did add another exhaust fan to be on the safe side. but the mouse is still hanging during normal operations.
tks

by pierrejamme

If the mouse is a USB, get an adapter to PS2. Some Win98Se and earlier USB support stinks. I have a dell form 1998 that I use a logitech mouseman (USB) did the sme thing until I plugged it in the PS2 slot. No problem since.

by megasurfer

I saw this one time when the USB port and the printer port were using the same IRQ. every time you printed something, the mouse would freeze up for a few seconds. Changed the IRQ for the printer port in the BIOS and it took care of the problem.

by dnc

Try changing out the mouse, could be faulty. Remove all peripherals, espescially USB type, and see if problem persists. If it's ok, then replace each peripheral one at a time until you find the problem child. DNC

This discussion is closed to new replies.