First, what was the software that you were installing? I hope this is helpful, I found this article on the Microsoft site:
Unsupported SCSI Commands When Using SCSI Pass Through
View products that this article applies to.
Article ID : 123677
Last Review : May 24, 2004
Revision : 2.1
This article was previously published under Q123677
SUMMARY
The following SCSI commands are unsupported when using SCSI pass through and SCSI pass through direct:
SCSI Command Value DDK operation code
---------------------------------------------
COPY 0x18 SCSIOP_COPY
COMPARE 0x39 SCSIOP_COMPARE
COPY AND COMPARE 0x3A SCSIOP_COPY_COMPARE
NOTE: The COPY AND COMPARE command is referred to as the COPY AND VERIFY command in the SCSI-2 specification.
If a SCSI pass through request is sent to the SCSI port driver with any one of these unsupported operation codes, the request will be rejected with a return status of STATUS_INVALID_DEVICE_REQUEST.
MORE INFORMATION
The described SCSI commands are identified as optional commands in the SCSI-2 specification. This means that not all direct access devices will support these commands. Some of these commands are also potentially dangerous to implement, because large amounts of data may be easily lost if they are used incorrectly.
Finally, implementation of these commands has security implications because large amounts of data might be handled without operating system control. For detailed descriptions of these commands, please see the SCSI-2 specification.