Question Locked

Stop Error Coes

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was upgrading from XP to Vista Ultimate and receivedthe following BSOD with the following codes: 0x0000008E (0xc0000005, 0x813A7877, 0x8dcfb108, 0x00000000). Each time I tried to install this error appeared. Now when I reboot, I have to select other windows system or it tries to continue the Vista install and I received the above BSOD. Any suggestions.
Thanx, Bill

7 replies

by captbilly1eye

The only time up to this point that I've seen that error message was in relation to a virus*. However, I doubt that is your situation.
Similar BSODs occur during installation of Vista when there is a hardware conflict or issue.
What does it say [b]after[/b] the numbers?
possibly - "IRQL_NOT_LESS_OR_EQUAL" or "INACCESSIBLE_BOOT_DEVICE"?
The error is a memory address that doesn't help much without it's accompanying text.

btw... if you're interested in reading about the virus I mentioned, here's a link:
http://tinyurl.com/3e4bhy

by sealdoc

Doesn't say anything after the error codes. Usually there is some kind of message as to what the code means, but in my case, I had the typical message before the codes "if this is the first time, etc." and then the codes as shown in my original post. The Vista compatibility software showed no problems for upgrading. Ran a virus scan before updating and showed a clean system.

R/Bill

by captbilly1eye

How much RAM is installed on the system?
Is this on a RAID config.?
Have you updated the system BIOS to the latest version?

One idea - if there is over 3gb of RAM, try reducing that by carefully removing some to get below the 3gb mark.

by sealdoc

System is a Dell 710H2c. Dell modified Nvidia 590 chipset, quad core (3.2 factory over), 4 gb 8500 ram, 2GTX 8800 SLI, 2x 160 gb striped and 2x 750 gb. Xtreme fidelity sound card and physix card. Just received the system two days ago, so assume Bios is current, but will check. Chipset is current. Will try reducing the RAM to 3GB as suggested.
Thanks, I'll let you know.

by sealdoc

I finally gave up in frustration. No matter what I tried, it just wouldn't load fully. Cleaned everything up (including registry) and tried 3-4 more times. Always hung with the same error codes. MS Tech no help. Finally did a new install of XP again and am leaving it at that for the time being.

Appreciate your help.

R/Bill

This discussion is closed to new replies.