Question Locked

Switch bios primary display from AGP to PCI and now can't see

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello:

I went into the bios and changed the primary display from AGP to PCI. Now I can't see anything. The motherboard is an intel d865gbf/d865perc and the onboard video is
supposed to be doing the displaying.
The OS is win2000sp4.

Help?

Andrew

4 replies

by cg it

If you have an onboard graphic card, BIOS will use that with the generic VGA driver to display POST screen. If you have an onboard graphics card AND you install a AGP card, you would need to turn off the onboard graphics card. Switching the "primary graphics card" option doesn't effect VGA during POST. So even if you changed it, during post, you still should have POST show on the monitor screen [unless you have both AGP card and built in video and you plugged in the D-sub connector to the wrong VGA port]

If you screw up and disable the onboard graphics card by mistake, you can reset the CMOS table and BIOS by powering off the computer, disconnect the power cable and either A remove the CMOS battery or B clear the CMOS table using clear CMOS jumper [remember to return the jumper to the original position]. your onboard video will be enabled by default so you can use that port [take out any PCI or AGP cards].

you should then have video during POST.

by thatguy_d82z

unplug the pc, then open it, and remove the nickel looking cmos battery placed somewhere on the mother board, (about 3/4 of an inch in diameter big)for about 15 minutes, insert it back in d mother board plug the pc, and vuala... you may have to adjust the pc clock(date/time) then restart if yur using a cable modem for the internet, if d cable modem (pc) light isnt on(data light isnt blinking.

This discussion is closed to new replies.