Question Locked

Switched ISP now can't access Remote Desktop

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We recently switched ISP Provders and access our system through Remote Desktop through Windows Server 2003 and Cisco Pix 501 Series Firewall. I know when we had our first ISP Provider we had to configure the Pix Firewall because of that ISP. Recently reset the Pix to factory default settings and still can not access the VPN externally.... (If connected directly to the network, you can access the server through 192.168.1.10)... I am a beginner to intermediate user and am not sure if there were configurations to Server that we had to do when the Pix configeration was initially modified? Any suggestions or ideas would be greatly appreciated...

P.S. the reason I beleive we changed a setting on the server is because even if I bypass the Pix Firewall, still cannot make a connection to the internet... (I beleive we disabled DCHP to make it work)...

Thanks

4 replies

by daveo2000

It is possible that your ISP (Internet Service Provider) blocks certain ports as part of their service. Some ISPs do not want companies to be running certain types of services inside of their networks or else they want to protect their clients from someone maliciously attempting to do this without the client's knowledge.

Talk to their tech support to see if they are blocking the ports you need and ask what you need to do to get these ports unblocked.

They may not be willing to unblock the ports but this shouldn't be seen as a roadblock, just a detour. You can set up your services on different ports and simply port forward at your firewall.

Make sure that your ISP is aware of what you are trying to do so they can give you advice or, at least, not think you are attempting something evil.

by swells

Is the PIX doing any port forwarding for the remote desktop protocol? Or do the servers have external/public IP's?

If there is port forwarding, check the rules to see if the old IP is being used instead of the new one from the new ISP.

by daveo2000

Good point. The original poster did mention resetting the PIX to factor defaults but I have, in more than one case, seen appliances reset some settings but not clean out everything. It would be wise to see if there are more than one levels of resetting so you can be sure to wipe out all residual configuration. I am not familiar with that particular appliance so I can't help you on that point.

This discussion is closed to new replies.