Question Locked

Symantec Antivirus Corporate Edition 10.1 Moving Clients

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi (Sorry for my bad english).

Well let me explain you my case, in my workplace we have a old SAVCE server and we need to put it in a new one. I already install the new server and i did a new primary server, everything fine until now. My problem is when I try to move ALL clients from the old server to the new one. I read some instructions from symantec and made a changes to the registry,in theory when the client do a check in in the old server the changes that i made it will redirect all of them to the new one but approximately from 200 clients only two change from server. Why only of these two clients change? I read too the other method, copy the GNC.dat file to the client but i can do that because there are a lot of them and there are in different locations. I hope first someone understand me :) and can help me. Thanks!

2 replies

by pser

Some major changes in this release. More on that later. Just know that there are MAJOR conflicts between older Client versions talking to a v10 server.

When you built the replacement Parent server, your best bet would have been to either down or rebuild the same box from scratch. Gave the new server the same name, IP, etc. In rev's. past that was all you needed to do. The information in the GRC.dat (on the client workstation) would not have changed (had you gone this route) and everything would have imported correctly.

Now, the fun part. SAVCE 10.x now uses SSL to push defs. (comm). This means that most likely you will have to install the latest client to all of your WS's.

Best thing to do right now, if you can, bring up your old Parent server. Make certain that all of your clients can see it and receive defs. Then, read ALL of the documentation in regards to old v. new. Develop a strategy for bringing up the new version while leaving the old up and running until everything has been upgraded.

I know, pain in the ass! However, this will be your best bet for a successful deployment of SAVCE 10.x.

Don't forget to check for the latest patches, as well. Both server and client.

Much luck to ya, I'll check back in when I can to see if you have any more questions.

This discussion is closed to new replies.