Discussion Locked

System re-boots itself

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My 1000Mhz system goes into a tight loop of re-booting itself. I can't even boot off a diskette. Any suggestions - hardware or virus oriented. I would re-build if a could boot of diskette

14 replies

by m.a.s. matrix

what type of os are you using? if you are running win2k, you can boot from cd-rom if your drive supports it. if you have use of another hard drive try a different one. start swaping out parts one at a time until you get it to work. that is if you have the parts available to you to do that.

if you find another way, please post here. i would like to know how this works out because i have had the same problem on my servers before and i just booted off the cd and did a repair.

thanks

by wanabedrsean

you need to check to see if the cpu fan is working you probably have an overheating problem or your processor is fried check your heat sink and make sure you have either a conductive pad or conductive compound in between the heatsink and processor when the processor gets to hot it reboots the machine for protection. this is a common problem with the 1 gig processors especialy the amd's need adequate cooling

by blackcurrant

This may sound obvious, but have you tried to change the boot sequence in your BIOS? Many BIOS programs let you change the order and some even allow you set a sequence that does not include a hard drive e.g. boot from Floppy then CD-ROM only.

Good luck

by mlusk

Win2k defaults to "reboot on any error". Remove this check box, and your system will blue screen instead of re-boot. You can use the error given to you from the blue screen to figure out the problem. (It's worth a try!)

by mark.sampson

My computer used to do that too. Open your case and make sure that the fan isnt covered in dust, and all of the air flow areas are clear. Try booting up and seeing how long it lasts for before (if) it reboots. If it still crashes then have a look atthe settings for Win2k and uncheck the "reboot on any errors) box.

by fenaikh

Hi
1- check voltage 110 0r 220.
2- check power suply may ahve a problem.
3- Heating problem CPU and power suply fans
4- CPU is bad. replace it or checkit in inother mother board.
5- Motherboard problem.

Good luck

Mohamed

by cbski

I'm closing this issue for know. I've sent motherboard back to tech - they found no problem with motherboard. I'm ordering a new case/power supply and going to try that. Thanks for all your suggestions.

This discussion is closed to new replies.