Discussion Locked

Termination of wires on RJ45 jack

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how do I connect(do termination) on the wires on RJ45 jack. i mean how do i configure the wires from the patch cable on the jack. i've done it once but I've forgotten. the jack is connected to patch panel by a patch cable and using a cross cable to connect to d hub/switch. thanx

4 replies

by ann777

Most of the jacks out there have color coded labels on the two sides of the jack.

Looking down on the jack (with the clip in the down position):

Left Front = green/white
Second Back = green solid
Third Back = orange/white
Forth Back = blue solid

Left Front = brown solid
Second Back = brown/white
Third Back = orange solid
Forth Back = blue/white

You need to twist every two (adjacent) wires together at the end, clip them off and then cap them down.

by ann777

Sorry, that secend set (beginning with brown solid) is on the right side of the jack looking down on it.

This discussion is closed to new replies.