Question Locked

Thermal paste on stock cooler

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I built a similar system a couple of months ago (with an E6400 instead) and when came the time to install the stock cooler/fan there was already some thermal paste on it so I just installed it as is. Would it be better if I take it out and add more or use better thermal paste. My system runs at stock speed (2.13 GHz) but I think it runs a little hot at about 45c. I believe it should run a bit cooler.
Thanks and congrats for the nice step-by-step instructions. It can be intimidating the first time you build a PC from scratch but your article makes it easy to follow...

3 replies

by jamesrl

The advice I've always followed is that the amount should be as thick as a piece of paper. Unless you've had a problem with overheating, I would not replace the paste.

James

by hal 9000

Except unless you touched the Thermal Paste then if you did you have contaminated it so you will need to remove the Heat Sink and wipe it clean as well as the CPU and then apply a small amount of thermal paste and reset the Heat Sink.

You do not want to apply too much Thermal Paste here as any excess will get squeezed out and eventually become contaminated and allow the contamination to spread through the entire layer of Thermal Paste stopping it transferring heat as well as it should.

Col

This discussion is closed to new replies.