Discussion Locked

To read from COM port

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a weighing m/c connected with COM port of my system .I want to read a set of data from it.I want to know wether it would be advisable to do in c++ or in VB?Can anybody guide me how to do the same.
Thank you!

1 reply

by johnfriz

Hi,

Assuming that you have VB5 or 6, you should have access to the MSComm control. (if not you can download an Active X wrapper for it here: http://ourworld.compuserve.com/homepages/richard_grier/xmcomm.htm This page also hase a lot of good info on reading from/writing to COM ports)

Here is a simple example using the MSComm control

' Buffer to hold input string
Dim Instring As String

' Use COM1.
MSComm1.CommPort = 1

' Tell the control to read entire buffer when Input
' is used.
MSComm1.InputLen = 0

' Open the port.

MSComm1.PortOpen = True

' Wait for data to come to the port.
Do
DoEvents
Loop Until MSComm1.InBufferCount >= 1

Read the info from the port
Instring = MSComm1.Input

' Close the serial port.MSComm1.PortOpen = False

Regards,
John.

This discussion is closed to new replies.