Question Locked

Toshiba laptop recovery disc fails to reinstall to factory default

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I cannot restore my Toshiba laptop to factory default using recovery CD. The first CD goes well but with the second CD, at around 50% completion, it gives an error message saying that a certain data file is lost. When I click OK the operation stops and CD ejects out. Instead of factory default option, if I choose to partition (10 GB out of 186 GB)the hard disk, I can by pass the first error message but then end up with another one at around 70% completion reporting another missing file. The more I increase the the partion size the later (in terms of % completion) I get an error message each time reporting the loss of a totally different file. Finally, however, I could overcome the problem and got a full restore when I choosed to increase the partition size to 36 GB. I was so happy ....but only to find that my system is extremely unstable to the point that whwnever I want do anything, even copying a file from a backup CD or download a file,the laptop starts the process only to go totally blackout in the middle of the process. I tried restarting the computer several times but the problem persists. When I cantacted toshiba support they suggest to try new recov CD and if that doesn't solve then to take my laptop to authorized dealer to check for hardware faults. Can anyone tell me what's actually going on? Is it a software or a hardware problem? Do you think a new CD can solve the problem?

12 replies

by older mycroft

What was the problem with the existing installation?

By varying the partition size, then experiencing an install error at varying points, I suspect you may have a dodgy hard drive. By changing the size of the primary partition, the installed data falls on differing hard drive areas until the bad area is once again encountered.

I'd go with the new install discs if they've been offered but be prepared for the purchase of a new hard drive. The install discs at least don't involve the expense of a new hard drive.

by bohurupi

While I was putting back my laptop on my desk it slipped from my hand to land on the desk from a height of an inch or so. The next day when it booted fine but I could find the system frozen. I restarted from safe mode, everything went well until I tried to do system restore. In the middle of restore the system stopped and went black out. I thot my battery went out and I immediately hooked to power adaptor but failed to boot the computer and realized that my laptop crashed. I tried all options for booting but everything failed. The laptop was engaged in a kind of booting-loop.

by older mycroft

If the laptop was switched on when the fall happened, you are lucky it booted again at all.

Even with power off, any trauma should be considered in the process of attempting to recover or reinstall an operating system.

A new hard drive may be the least of your worries.

by Former member

So no code that is on the drive disrupts the code that you are putting on (software in this case). So when you have wiped the drive, then put in your recovery disks. Wipe drive software here:
http://dban.sourceforge.net/
Download this in a cd format and burn it then run it on your computer. It is free, so give it a go.

Please post back if you have any more problems or questions.

by bohurupi

thanks Peconet Tietokoneet, please read my response to old mycroft question. Would you still stick to your suggestion?

by Former member

It could just be your hdd, the arm might have damaged the drive and so that is why you are getting this problem

Please post back if you have any more problems or questions.

by Former member

It helps us to give you a more straight answer to your question if you tell us the full history. If you want to post in future then give us a full (not part) description of what you have done. It makes it easier for us and you. Unless you are Neither of Either. :)

Please post back if you have any more problems or questions.

by older mycroft

Either unhelpful or 'hoping it wouldn't matter if never mentioned'. ;)

by Former member

Completely unworthy to post. Or Neither of Either.

Please post back if you have any more problems or questions.

by bohurupi

Thanks, peconet, I was not sure that the drop could be the reason because it was only from a height of an inch or so and the impact didn't sound to me quite great and didn't not tempted me to check out immediately. The laptop was also totally shut down. I my first impression was that some kind of software conflicts caused the problem. Also, my understanding was that the laptop would have some sort of shock absorbing capacity and would not boot had there been any physical injury to the system. Now reading all these posts I am getting to believe the problem might be related to hardwares. My question is, how could you be sure that the problem is in the HDD and not in other physical sectors like memory, CPU etc?

by Former member

More info here:
http://buytough.com/panasonic-tough-notebooks.asp

Yours (and this includes mine) do not have this shock protection system built in, so in the end it is your hdd that is gone. So get another one (hopefully you have not damaged the motherboard) and test it out if ok then you are lucky. :) If not then your motherboard has a crack in it.

Please post back if you have any more problems or questions.

This discussion is closed to new replies.