Question Locked

Toshiba M400 won't recognize a new cloned hard drive

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I put a new hard drive (it's a WD 3200BEVT) into my Toshiba M400 and Windows XP won't recognize it.

The BIOS sees it just fine, and when I boot using the old drive, and plug the new one in to the USB port it shows up as well.

I cloned the drive using a hard drive upgrade kit from Apricorn. Looking at the drives in Windows Explorer, they appear to be identical.

Help!

5 replies

by dave.gray

Thanks for your note Col,

I'm sure I cloned the hard drive because I used a cloning software called EZGig that came with the upgrade kit.

I had to boot from a CD and clone from one drive to the other. The software told me that the cloning was successful.

I don't have the original XP CD which is a problem.

Should I try another cloning software?

by oh smeg

When fitted to a computer.

The only thing here is that the computer may not support SATA 2 Drives and you may need to fit a jumper to the SATA Drive to limit it's internal speed to SATA 1.

That could be an issue as your M'Board Chip Set may not recognize or support the newer SATA 2 Platform.

I've only ever used Ghost or Acronis True Image to Clone with previously and both of these work perfectly.

You can find details of Acronis here

http://tinyurl.com/64egh7

and Ghost here

http://tinyurl.com/25qub5

Col

Col

by rob miners

and see if you can get into the Recovery. Boot the device while holding down zero (0). The other alternative is to use the Recovery DVD.

This discussion is closed to new replies.