Question Locked

Toshiba Satellite - laptop Hard Drive replacement

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My Toshiba laptop had 60GB Toshiba hard drive. Week ago my laptop did not boot up and after several attemps I tried to restore factory default through CD provided by Toshiba. It could not restore Factory default with error message " WRITE SETOR FAILURE RESULT = 1 DRIVE = 128 SECTOR 37119 TO 37183".

I ordered new Toshiba hard drive of 80 GB and installed it but upon boot up this hard drive is not recognized. Upon pressing F2 in boot up setting it shows... HRAD DRIVE - NO.
How do I make my new hard drive recognized during boot up.
Is there any else required for installing new hard drive?

12 replies

by computacentre

Look for ide section and run the detection option supplied. Its probably on auto as your old hdd was dead

by nipulshah

IDE section in BIOS is set to BOTH (both primary and secondary are enabled). And there is no option to run any kind of detection over there.

Surprsingly when I put back my old HDD then also BIOS shows hard Disk - NONE.

I have no clue what is next that I should do?

by peterjhansen

Nipulshah, I have the same problem. Did you fix your problem, and if so, how?

I have a Toshiba Satellite A65 laptop. My BIOS does not see the hard drive, see a secondary drive. I successfully installed Windows on a new drive, a 60Gb Toshiba. When I boot up using the Windows recovery console, I can see the formatted hard drive, with Windows XP installed. I also ran chkdsk, and fixboot. Still, the BIOS does not see the drive on boot.

If anyone has insights, please help.

by peterjhansen

Nipulshah, I have the same problem. Did you fix your problem, and if so, how?

I have a Toshiba Satellite A65 laptop. My BIOS does not see the hard drive, see a secondary drive. I successfully installed Windows on a new drive, a 60Gb Toshiba. When I boot up using the Windows recovery console, I can see the formatted hard drive, with Windows XP installed. I also ran chkdsk, and fixboot. Still, the BIOS does not see the drive on boot.

If anyone has insights, please help.

by rob miners

know if it will help but try putting the drive in upside down.

by bugeyedbeast

Hello there, this is my first reply here. I think you may find that the new harddrive is not formatted. that is, there is no file system on it whatsoever. just a blank disk. If installing windows XP then the disk needs to be prepared first, so that the disk can be found and then the operating system installed on it.

by nocalls

I take it that no one has figured out how to get a Toshiba Notebook to recognize a new and larger Hard Drive. I am having the same problem with my Satelitte 4315. It won recog the new drive. Even a new drive should be recognized and formatted by Windows XP. Any Help hot there??

by trefalgar

LOL AS crazy as it may seem ... I installed the hard drive what appeared to be the most logical and correct way .. if you watch the pins on ur puter and line them up correctly .. they go in the other way, carrier side up, not label side up .. IM SUCH A DORK#%^^#@# LOL give it a try if ur having trouble ... I was getting in bios .. HDD NONE try it... youll be surprised

by gkwoodard

Did you take the adapter block off the old hard drive. If not the pins will not line up properly on new hard drive. The adapter plugs into the ide pins

by ariqjohn

Good call gkwoodward, I compared the old and new hard drives side-by-side and noticed the glaring difference, the adapter block. Simply pull it off the old drive and slide it onto the pins of the new drive. Thanks for the posts everyone!

by jon

Could you please put your model of your laptop, and new hard drive model on here so, I can look for something. Also, did this laptop come pre-installed with windows vista. I should be able to give you an anser after some information is filled in.

This discussion is closed to new replies.