Question Locked

Toshiba Satellite

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Cant get my new HD to be reconized by my toshiba sattellite I get "NO C DRIVE "error. I am trying to replace the bad old 20 gb hd with a new 30gb Toshiba hd Please help

2 replies

by oh smeg

Yes you can but there are a couple of Provisions that need to be followed first.

If the 20 GIG was the biggest HDD that this unit could use then you can not use a larger capacity HDD in it. Though if 20 GIG was the starting HDD installed in these then you should be able to use a 30 GIG HDD without problems though it will need to be correctly Jumpered.

2.5 Inch HDD have a Plastic Jumper that can be either completely removed or moved to 1 of 3 sets of 2 pins to set the HDD to either Master, Slave or Cable Select CS. You need to look at the old HDD that came out of this system and see if it has a Piece of Plastic over 2 of the 6 unused pins when it is plugged into the NB. If it does you need to move the Jumper on the new Drive to the same Position and if it doesn't have a jumper at all fitted you need to remove the Jumper from this HDD so that it will work correctly with this NB.

It is also possible to update the BIOS if your Model NB has a new version available and this may allow for a increase of Supported HDD size but you need to read the Warnings and proceed carefully here or you could wipe the BIOS Chip which effectively destroys the M'Board in the Note Book.

Also after replacing the HDD on these older systems you need to open the BIOS and make sure that the HDD is correctly recognized then save the changes as you exit the BIOS. This will save the changed configuration Data of the new HDD to the system so it can be correctly recognized and Mapped. Basically if the BIOS fails to read the full capacity of the HDD correctly it doesn't support that size HDD. Of course if the HDD has a Limiting Size Jumper on it and this is set to limit the size of the HDD the BIOS will only see the Limited Size of the HDD and this is perfectly OK. Though I don't think that 30 GIG HDD have this option but you still need to read the Sticker on the drive to see what it says.

Col

This discussion is closed to new replies.