Question Locked

tyan two tone continuous beeping

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a tyan mb that is giving me a continuous two tone beep on power up. I'm not getting any video. I can't find any explaination of that beep code anywhere associated with Tyan or with Phoenix BIOS. Anybody know what it means?

4 replies

by thechas

Two tone (Siren) beep codes are almost always critical hardware faults.

Typically, either the CPU fan is spinning too slow. Or one of the voltage levels is out of limits.

The BIOS is likely set to stop on these types of failures.

Check and make sure that the fan spins freely and is plugged into the correct jack on the board. Even if the fan spins ok, the RPM output may have failed and a new fan might be all that you need.

Chas

by comet

I just fixed a problem like this in one of my PC's with an AMI BIOS.

It is probably a temperature/fan indicator set to beep by a setting in your BIOS.

In my case the cpu fan was reporting 0 RPMs and the fan error was set to "beep".

But since the fan was actually working, I simply set the fan error to "nothing" and all the beeping stopped.

This discussion is closed to new replies.