Ultra ATA controllers?

You may have to either remove the devices and redetect them and install the drivers or you may be able to just update the drivers. Code 10 usually indicates a problem with the device driver. Good luck

You should run a virus scan with the current defs updated. This is a signiture of several virus families, we see it in the shop all the time. If no virus is found, try disconnecting the devices attatched to the busses one at a time. A device failure can also cause the bus to go into contention. One other thing to try if these both fail is to reinstall the op sys over the top of the one you have now. Sometimes that works.

Good luck,

Vickie

This question was auto closed due to inactivity