Question Locked

UNABLE TO OVERWRITE A TAPE IN BE 12.5

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running Backup Ecec 12.5 on a Windows 2003 Small Business server. After replacing the tapes with new ones I get one backup per tape and then the next time I run it the job stays in the Queing status and never runs. I have checke overwrite protection on the tapes as well as on the media set. Both are set to overwrite.

6 replies

by oh smeg

To never Overwrite Data.

So other than changing Tapes what else did you do here?

Col

by gpalmer

Here is what I know. The customer's support agreement expired in November. They said that is when the problems started. Not this particular issue though. Anyway they recently migrated to a new Dell Server and quite possibly since then the problem has been happening. I cannot deny or confirm that. However there must be a switch that I am unaware of in the Software because a new scratch tape will backup just fine. I have set the tape's media set into a group that is overwrite as well as changed the policy to overwrite. Not sure where else I have to tell it to overwrite the tape.

by oh smeg

And reinstalling it properly this time?

If they have a new server I'm assuming that they chose to install this software on this new device and it is possible that they did something wrong there.

Col

by gpalmer

No. I am trying to avoid that if possible. One issue I noticed is the drive will not see a tape inserted unless I inventory the drive however it will run or attempt to run a backup anyway. As you can see I am not an expert in Backup Exec. However after lableing a tape I would expect that upon insertion in the Sony drive the software should see the media lable. That is not happening either.

by shasca

Is the retention policy set, and backup type? Differential,Incremental,full. It may be so out of whack that it will only accept a blank tape until it's configured.

Is this new drive compatible with this version of BE?
Are these the right tapes for this drive?
They may only work as read not write or visa versa due to incompatibilty.
You need to look at a lot more of the compatibilty and configuration to help figure it out.

This discussion is closed to new replies.