Discussion Locked

Uninstallation of USB Scanner

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
System worked fine until I took out my printer port and installed the usb cable with hub. Installed software and hooked up scanner but scanner defective so I uninstalled the usb cable and hub and tried to reinstall my printer port. Now system will only go into safe mode. I changed settings in setup and changed them back when trying to put printer back in. Nothing works I'm stuck in safe mode. What do I do???

3 replies

by thechas

Which version of Windows?

Assuming Windows 9X,

What you may need to do, is go back into setup, and enable the USB ports again.
Windows can react in strange ways when you remove hardware without first telling Windows that you are going to remove the hardware.

If you can now boot into standard mode,
enter device manager, (right click on the My Computer icon and select properties).

Select the device manager tab.

Expand the branches, and select and remove the USB ports, hub and scanner if listed.

(Post a comment to your question if you see any devices that have a yellow "?" or "!" in front of them.)

Close device manager, and shut down.

When you boot back up, enter setup and disable the USB ports.

Save the changes and exit setup.

Windows should boot normally with no issues.

Now, for your printer port;
Check device manager under the ports section and see if a printer port is listed.
If there is a printer port and it is NOT EPP/ECP port, remove it also.
Restart, and enter setup.
On the peripherals page, enable the printer port and verify that the mode is EPP/ECP.
Save changes and exit.

Windows should find the port and install the driver for it.

Now, follow the printer manufactures instructions to install their driver.

Chas

by dmiles

The first thing that you would want to do is make sure that you have your software for your scanner before we start making any changes to your configuration. After locating your software, uninstall your scanner completely. This can be done by clicking on Start --> Settings --> Control Panel. Double-click on the Add/Remove Programs icon. From the list of programs installed on your machine, select the scanner from the list and click on the Add/Remove button.

Now that you have the scanner uninstalled it?s time to turn your computer off. Go ahead and unplug the USB cable out the back of the computer and out of the back of the scanner. Unplug the power cable from the back of the scanner and out of the power source (the outlet in the wall or surge protector). With everything unplugged, reboot your machine. Check your device manager by going into control panel again, but this time double-click on the System icon and click on the device manager tab. While in device manager look for any yellow question marks or red x?s. Pay special attention to the last device which is the Universal Serial Bus Controller. It is very important that there are no errors on the USB controller, because this is key to your USB scanner working properly. Ifthere are any errors, please contact the Desktop Support Helpdesk at x5470, menu option #2, to inform them of the error.

If there are no errors, reinstall the scanner software and turn the machine off. With the machine off, plug the USB cable in the back of the scanner and then in the back of the computer. Next, plug the power cable back into the scanner and into the power outlet. Turn your scanner on if it is not already on. Now turn on your machine. When booting up, windows should detect the scanner and install it

by littledebbie

Thank-you TheChas You were right to assume windows 98 and your soultion worked perfectly although had the scanner not been defective i believe the installation went perfectly. Now my printer is re-installed and when I get a new scanner I believe I will be able to install it no Problem. Thanks again. Littledebbie

This discussion is closed to new replies.