Discussion Locked

Upgraded to XP & partition: access deny

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have my HD divided into 3 partitions. C: system, D: documents E: misc. I upgraded from W2K to WXP pro, reformatted/installed OS on C: drive. When installation was done, I get an access denied trying to open the D drive. I checked the propertiesand it said RAW. The E: drive is still intact with no data loss. How can I recover my documents on the D: drive. First of all, what do you think happened? Second, how can I recover my files? Can anyone recommend a solution please?

Someone suggested that I reinstall W2K and see if I can access my drive back, but that didnt work. BTW, when I was installing W2K and it listed the partitions, during the install D: was marked as listed as NTFS, but in after the install it's marked as RAW.

5 replies

by sbarter

Have you tried going into the Microsoft Management Console (MMC), to the section under storage titled 'Disk Management' to see if there are any clues as to why you are being denied access?

by techplus4u

system load probably changed the partition
first do not make any more changes to the drive if your data is important.
when I have a situation like this I pull the drive set it up in another machine I have setup just to recover data first before triing to repair the partition.if you have access to another system set it up as the second or third etc. drive. there are few good programs that are easy to use (easy recovery for one). if you do not have acess to another machine, setup another drive as your primary drive. partition and format new drive(2 partitions, win 98 fat 32) leaving enough room on second partition to recover data to. load system, antivirus and recovery tool with the other drive diconected. name second partiton (recover or what ever you like) so it is easy to spot. some recover programs will id the partition by name, some dont. you want to be sure which partition you recover to. I always use a seperate drive for this it keeps it simple. main drive maxtor ,, recoverdrive ibm ect. set 1 recycle bin for all partitions to be on drive c: after this is all set up you can then connect your drive and begin recovery. good luck, if one tool does not work don't make any changes to the drive your triing to recover unplug it and look for other tools. there are other good dos based tools and other methods depending on how much you need the data. tiamisu is an old dos based program not sure if the are around anymore /older norton pro had a 3 disk er set that had some undelete features.. there many other programs. in some instances such as a failing drive you want to clone the drive bit by bit and do the recovery from the copy. hope this helps

by lksubscribe

Never gained access to the drive. Used Easy Recovery Pro (RAW) to recover files. Reformated drive to NTFS.

This discussion is closed to new replies.