Question Locked

Urgent, need help configuring Cisco 2600 router

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am currently stationed in Afghanistan at a very remote base with a satellite connection for internet. Our Linksys router sh*t the bed, so until I can get this spare 2600 router configured we can only have one computer hooked up at a time, and its hurting morale. Although I am an IT, the Navy has provided me with no network training, so I am operating on the little bit of knowledge that I have from home networking and use of google.

I have been able to configure everything I need on the router, except the most important part for my situation, the NAT. I have read documents on both this site and Cisco, but I just don't have enough experience to understand exactly what it is that I am doing/need to do.

Normally I would spend how ever long it takes to figure it out, but at this point I would much prefer for it to just to get it up so the guys can talk to their families. I would really appreciate it if someone could help me out.

Here is what I am working with:

Satellite modem/gateway IP address is 88.202.18.abc.

I have assigned an IP address of 88.202.18.abd
to my FastEthernet 0/1 interface, and an ip address of 172.16.0.1 to my FastEthernet 0/0 interface for our private network. I have another static IP address, 88.202.18.abe available for use if needed.

I have my DHCP server setup as 172.16.0.254, and it assigns IP addresses/dns servers to my clients as it should. I still can't see the internet despite fiddling around with a lot of NAT commands.

Any help is greatly appreciated.

-Bryan

2 replies

by jagdpanzer

i cut this down to as simple as possible
good luck, if it does't work, post as much of your config as you can

interface ethernet 0/1
ip address 172.16.0.1 255.255.255.0
ip nat inside

!--- Defines Ethernet 0 with an IP address and as a NAT inside interface.

interface serial 0
ip address 88.202.18.abc 255.255.255.0
ip nat outside

!--- Defines serial 0 with an IP address and as a NAT outside interface.

ip nat pool no-overload 88.202.18.1 88.202.18.63 prefix 24
!(outside addressing)

!--- Defines a NAT pool named no-overload with a range of addresses
!--- 88.202.18.1 88.202.18.63.

ip nat inside source list 7 pool no-overload
!
!

!--- Indicates that any packets received on the inside interface that
!--- are permitted by access-list 7
!--- will have the source address translated to an address out of the
!--- NAT pool "no-overload".

(inside addressing)
access-list 7 permit 172.16.0.0 0.0.0.31

!--- Access-list 7 permits packets with source addresses ranging from
!--- 172.16.0.0 through 172.16.0.31.

This discussion is closed to new replies.