Question Locked

USB-parallel adapter for parallel type hardware lock

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I use some 2003 version software that uses a hardware lock device (parallel port plug in). My company has upgraded laptops without the 25 pin serial/parallel interface. I purchased a USB-parallel adapter but the computer does not detect the hardware lock. What can I do?

5 replies

by oh smeg

You may need a different USB-LPT Port Adapter.

Some of these devices are not overly compatible with Vista so you need a USB to LPT Adapter from a different Maker as the Chip Set may not be completely compatible with Vista. If however it is you need to contact the Software maker and buy a new solution from them to run with Vista.

Then depending on the type of NB you may be able to use any fitted Expansion Slots to fit a PCMCIA/Cardbus Printer Adapter but this all depends on what the NB has as it's base features. If there is no expansions slot/s then this isn't an option and depending on the type of Expansion Slots if fitted there may not be a plug in Printer Port Adapter or the ones available may not have the required drivers to work with the OS you are using.

When you fitted the USB Device did you install any software that came with it?

This should have been factored into the Upgrade Costs when you replaced the NB's. If your IT Section/Consultant didn't warn you of these potential Problems you may have a case for a Professional Negligence Claim against them naturally this only applies to a External Company who supplies your IT Requirements and if you have an internal IT Section you should look at training for them as they are not providing the best service possible through a lack of understanding of how the applied Technology work for your Business.

But if you just approached several companies for quotes for the replacement NB's without fully informing them of your needs that is your fault not theres as they where not fully informed of your particular requirements.

Col

by thechas

Has anyone checked with the company that supports the software that requires the hardware key?

It is very possible that they offer a USB dongle that does the same job. At a minimum, they should know what specific USB to Parallel adapters will work with their keys.

Chas

by older mycroft

Given that it should surely search for the parallel port during installation ?

Perhaps I've got the wrong end of the virtual stick ?

by mjd420nova

I spent a lot of time looking into this for a number of clients and found that there are no USB to parallel adapters that will work for those hardware locks, at least I haven't found any and I've tried over a dozen different ones. The only cure was a parallel port plugin card that does a good job. Check out your local Office Depot or Fry's Electronics.

This discussion is closed to new replies.