Question Locked

USB Wireless Adapter

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Will a USB wireless dongle work in a USB 1 port on W98ME?
The OVISLINK W54USB works fine in a USB 2 pc running XP but on the former it drops connections every 2 or 3 minutes and then just fails to recognise any network. The manufacturers driver states that it supports W9x.

5 replies

by hal 9000

It should work on 98 but you'll need to look at the signal strength and because you only have USB1 it's going to be slower than a USB 2 Port could be,

Look at the instructions that come with the 9X Drivers to setup the unit correctly.

Col

by mjd420nova

The only way I could get the thing to work properly was to install a NIC and wire it to the router. I was unable to get any USB1 to work at all under WINME, even tried a direct USB1 connection straight to the cable modem and couldn't get anywhere. Good luck

by mib.2945

Windows 98 and ME have known power issues with usb devices. The item will continuously desync like that. Wireless devices especially seem to have that issue. They try and draw more power than windows feeds them.

by takaharu

For Windows 2000 and later I know that when a USB 2 device is plugged into a USB 1 port, it will notify the user and state that the device will run slower. WinME I hate so I can't say whether that would work.
I think it's safe to say that if you used USB 2 with Win98 then it would at least work. If the device was designed for USB 2 then I think it's safe to assume it's better to at least try USB 2 with an older OS.
You can pick up USB ports for peanuts nowadays so try that.

This discussion is closed to new replies.