Question Locked

video card goes on and off

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an e machines t6420 with 2 gb of ram in which I have installed an nvidea geforce 7600 gtoc video card (pcie). at first there were no problems but after a few months I shut off the computer and when I turned it back on I was getting no visual signal from the pcie and the onboard (nvidia6100)card had kicked in. I have since then changed the video card about 3 times changed the mobo and obtained a new power supply. When I installed the new power supply I actually began to get a signal from the pcie card again but the function is erratic. Usually when i turn on the pc the pcie will not work and the onboard is on, when this happens the monitor sometimes will get a blue tint off and on. after a few hours use if i shut down the pc and turn it back on in 30 minutes or so the PCI might go on and work just fine but if I shut off usually the next time i turn it on the onboard will be on and the pci will be off again. Under advanced chipset in bios its set to pcie, I have tried uninstalling and reinstalling the drivers and nothing seems to work.

3 replies

by mjd420nova

Sounds like a CMOS/BIOS problem. It wants to revert back to the onboard video?? Is that the BIOS default setting?? Intermittent video on boot up is usually the video card, and or the slot it sits in. Having changed the MOBO didn't cure the fault is misleading. I have seen some faults like this, and it was created by a driver not being reset by the software when modes were changed, either by your choice or by running a program that changed the video drivers from the Nvidia ones to the on board, but not back again.

by funkid79

on bios settings under advanced chipset settings its set to pci express so i'm not sure what else I can do any ideas on how to fix this?

This discussion is closed to new replies.