Discussion Locked

Virus update results in looping reboot

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Im running windows 2000 .I recently updated my NAV definitions using Live Update. I was asked to reboot , it did as usual and boots up all the way to where its applying security settings and then loops back into a reboot again . It will boot into safe mode.
Is there a way to rewind 2000 like on ME? Can I edit the file that controls rebooting ? Can I blame NAV? Anyway any help would be greatly appreciated.....

Thank you in advance , Darren Moeller

7 replies

by omegatwb

From the sytems properties - advanced tab, starup recovery uncheck auto-reboot. That will get you out of the endless reboot loop. Are you "blue screening", you may want to uninstall NAV from safe mode, run Chkdsk /f to clean up and then reinstall.

by rkelly

Have you tried Last Known Good from the Advanced Startup Menu. Your problem sounds like a bad registry update, and providing that you haven't managed to login you can reset your registry by using Last Known Good.

by r.migliore

Darren
This might be a stretch, Check your BIOS and make sure that the power management is properly configured. I ran into these problems during the initial W2K install on Dell desktops.
Good luck.

This discussion is closed to new replies.