Question Locked

w2k only recognizes 128gb of 300gb sata hard drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I bought a 320gb Maxtor SATA II/300 to use for data only. My first SATA experience.

I used fdisk to make 5 partitions using percentages and it shows each partition at correct capacity.

BIOS recognizes full 320gb capacity.

Windows 2000 pro service pack 4 disk management only recognizes it as 128gb.

Maxblast only recognized it as 137gb (Maxblast not used) and Belarc Advisor shows it as 137gb.

I have an Intel D945GCCR motherboard and P4 3.2Ghz processor with HT. One 80gb PATA hard drive.

I have a 160gb PATA hard drive in an external USB enclosure that I use for backup and it's recognized complete.

If all else fails, if I use a SATA to USB converter would the 320gb be recognized complete?

Thanks to anyone who can help.

7 replies

by ic-it

What version (OS) did you use the FDisk from?
How large and what type of partitions are they (Primary/Logical, FAT32/NTFS)?
Are any of the partitions recognized?
The BIOS and W2K are updated enough to address 48Bit. Have you installed the Intel Chipset Drivers esp. the Intel Application Accelerator v2.3
Last thought, you may need to enter the Registry and verify that it is enabled. See this article for more info.
http://support.microsoft.com/kb/305098

by 37toms56

Thanks for your reply bwilmot@, sorry to take so long replying, my wife broke her hip a couple of weeks ago and I spend as much time with her as I can.

I used win98 install startup disk. Properties doesn't give the fdisk version, but I imagine it's DOS 6.22 or possibly 7.

One primary (I tried both inactive and active. The hard drive is for data only) and four logical, all FAT32 partitions. Fdisk shows each at 61000+mb, I used 20% for each partition.

Win2k doesn't recognize any partitions. Disk management just shows one 128gb disk with no partitions and unformatted.

Intel Application Accelerator v2.3 says it's not compatible with my chipset (945GV).

BIOS setup recognizes the full 320gb capacity.

W2k recognizes 160gb and 200gb PATA hard drives that I have, so the issue seems to be SATA.

Somewhere on the umpteen pages I read at Microsoft said that Service Pack 4 would permit hard drives into terabytes, but at the time that was written SATA wasn't around and I can't find info on large SATA at Microsoft.

Here is an excerpt from the motherboard manual, "The interface also supports
second-generation SATA drives. The BIOS determines the capabilities of each drive
and configures them to optimize capacity and performance. To take advantage of the
high capacities typically available today, hard drives are automatically configured for
Logical Block Addressing (LBA) and to PIO Mode 3 or 4, depending on the capability of
the drive."

Thanks

by ic-it

My Bad on the intel, that was only for the 800 series chipsets. If the 98 fdisk recognized the correct size than it was at least a 98SE version. Did you also format the partitions?
Worst case scenario (last resort) download the WinMe boot disk from www.bootdisk.com and try the fdisk/format again.
Have you installed the Sata drivers for W2K?
USB should work, but will be slower.
Verify that all updates to the OS have been installed. Check the Security Tab of the drive and insure there are no strange entries.

by 37toms56

Now is time for the red face.

I had assumed (the great time wasting thought patterns) that the large hd must be enabled in that haunted forest full of brambles called the registry, since the large PATA hard drives were recognized. I finally built courage and jumped into the registry with both feet and discovered the entry wasn't there. I made the entry and lo and behold there was my new SATA 320gb hard drive in it's entirety.

Thanks for your help and jump starting my brain. You'd think after 70 years it would go on it's own, but sometimes it doesn't.

I'll never assume something again, at least not until this afternoon.

by ic-it

I am glad you got it squared away. Don't be embarrassed, we all do it at times.

This discussion is closed to new replies.