Question Locked

WD hard drive power issue?

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a WD 500g external HD - powered it up today and the green light on the power box is very faint and flashes. It does not power the HD up at all.

When I remove the HD the power light goes back to solid green, but as soon as the power goes to the HD it returns to the faint flash.

Would this be as power cable issue? Or is my HD dead?

I did try another power point in case THAT was the issue but it didn't make any difference - though it DID get to power up the HD and I had a blue light on that temporarily until I turned it off - thinking it DID work and meaning to put it back into the surge-protected power socket!

Thanks

Cathy

2 replies

by oh smeg

Really here it could be either.

It could be that the Plug Pack has been overloaded and has failed and is no longer supplying either the right Voltage or Current.

Or it could just as easily be a short Circuit inside the Enclosure pulling the Voltage and or current from the Plug Pack low and not providing enough power to power the internals of the Enclosure.

You could start off by testing the Power Pack with a Multimeter set to 20V DC and see what it is reading there.

Col

This discussion is closed to new replies.