Question Locked

WebServer bandwidth requirements

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello all,

I have been tasked with setting up a web server system for a professional business website that is going to be dishing out a lot of video. I am wondering what bandwidth requirements I can expect for this kind of system. I know it is hard to say without knowing how many hit/views I will be having, but I estimate it at around 40-50 concurrent videos being pushed at the same time. I am thinking about getting a full T1, but I have never dealt with the actual installation of a T1 before, only the occasional popping the card out and back in during issues type stuff.

A bit about me, I have a CS degree and have worked as a level1 network admin before, but I have never setup the entire system from scratch on my own before. The server setup will be a a netBSD (open to suggestions) system running LAMP. As for the firewall I am not sure what I should use. I was thinking of running another dedicated openBSD system running iptables, but I am now wondering if it is better to run a dedicated cisco type system instead?

I have so many questions about this stuff, and I have pretty much been thrown into the mix to make it happen over the next month. I am currently questioning if I have enough knowledge to pull it off. so in other words... HELP!

Thanks all!

5 replies

by 1bn0

Put the video on You Tube and imbed the video in your pages via a link

by cmarsh

The industry I am in is of the adult nature, and that doesn't work for us. All of our video has to be streamed via our servers.

by jaqui

you are looking, for the content you mention in your response, at needing at least a terabyte of data transfer.

T1 won't cut it.

OC3 is where that needs to be.

you can't implement a LAMP stack on a netBSD system, the L in LAMP is Linux ;)

You would be better off to go with the Cisco appliances for the routing and firewall, far easier to maintain.

You'll have to look a the "fine print" in the service provider's T.O.S., many don't allow adult content at all.

by cmarsh

Yeah the main shareholder wanted to do it all in house, but after looking at the streaming BW required 1.5mb/sec per stream, a T1 is definitely not going to cut it. So I am going to have to do a co-lo probably at the interchange in Atlanta. Hrmm, I guess I assumed BSD would do a LAMP arch without a problem, if that is the case I could probably use a locked down fedora or maybe even RHEL as the web server. Maybe an F5 load balancer in the mix and two or three of the web servers. Not really sure yet still investigating.

Thanks for the replies.

This discussion is closed to new replies.