Question Locked

Western Digital hard disk 120 Gb is not getting recognized when connected

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently bought a Western Digital 120GB hard drive (the model number is something like WD1200U17-001). This morning I backed up some files as I was going to re-install Windows XP on my laptop. Now, when I plug it in I get a "Safely Remove Hardware" message, but the drive does not appear in My Computer and I cannot access it. The device appears in Device Manager. I've tried uninstalling the driver and then re-connecting it; Windows appears to detect it (launches the 'Found New Hardware' popup) but it still does not appear. I tried this on another computer and the same problem happened.

6 replies

by bart777

Windows may see the drive but not be able to access it if the format is wrong. Take a look in disk management and see if it recognizes that formatting. You may need to reformat the new drive.

by cookieorc

to get to disk management:
Right click my computer
select manage
then select Disk management.

You will (assuming it is Disk1) right click on Disk1 and select format. You can figure it out from there.

by lucamarcus

I have the same problem with my 80GB Western Digital Disk and its not seen in Disk Manager but i can see it as a Disk in Device Manager and its not there under My Computer so what do i do?

by bill stuntz

I've seen this problem fairly often on networked machines with USB Flash Drives & HD's.

Let's say that you have 3 physical drives - C: D: E: and a network share mapped to F:

The USB storage driver tries to assign itself to the next PHYSICAL drive letter. It ignores the fact that F: is already in use by a mapped network share & tries to install itself there anyway! It appears to be a bug in Windows. If that's what's happening, there are several solutions.

OK: Disconnect the network drive & remap it to a different drive letter, leaving a few unused drive letters in between. That way any new USB drives have a "next" letter available to grab, even if you connect more than one at a time.
PRO: You'll never see the problem again.
CON: Any links to the data on your network will be broken.

Workarounds if network drive HAS to be F:
Use Disk Management to change drive letters.

OK: Change your CD/DVD drive letters - I use R: for Read only & W: for Write capable devices.
PRO: It gives you a couple available letters between C: and your mapped network drive.
CON: May give you a little trouble for applications that expect the CD to be in the drive letter they were installed from.

Poor: Find the USB drive and change its drive letter to something else - I usually use U: for USB.
PRO: THIS drive works.
CON: If you connect a different device, you'll have the same problem with it.

by pjamese3

I think it's a problem with a registry change. I formatted and reinstalled Windows XP on a computer and installed updates and software using my WD 250GB external. After putting the computer on the network, I was unable to access the drive. XP recognized the external drive installed, but keeps asking for drivers. I haven't formatted my drive and it works fine in another XP machine not on the network and in my personal Vista machine.

This discussion is closed to new replies.