Question Locked

What about booting from USB harddisk?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Any help to boot from external harddisk?

8 replies

by nicknielsen

As long as the BIOS in your PC supports USB devices, it's very simple to set up. To check for BIOS support and set up the PC, do the following:

1. Start your PC's BIOS utility by pressing the correct button during startup.

2. Use the arrow keys to select the "Startup" option, then press Enter.

3. Select "Boot Sequence" and press enter.

4. This screen will have several lines and look something like this:

First: Removable Drive
Second: USB Device
Third: CD-ROM
Fourth: Hard Drive

If the BIOS supports USB booting, an option will usually be visible. You may also change the boot sequence while you are at this screen. Follow the directions provided by your BIOS manufacturer.

If "USB Device" is not available as a boot option, your BIOS does not support USB booting. You will have to upgrade or purchase a new mainboard.

Hope this helps.

by cefiro2266

Thanks for the long and detail reply.

Yes, the machine supports USB booting. I had tried using the same procedures 1 year ago, but it just fail to boot from external hd. In fact it try to boot from this external hd, and I can see the Windows logo, but after that it just keep restarting the machine again and again with endless loop.

If I swap the external hd to main hd then it boots.

I am not too sure whether it is due to BIOS bugs or ....

by nicknielsen

I have a couple of externals that do this because they are not bootable drives. Is your drive properly configured?

by zlitocook

Your computer supports it. How to tell is put a flash drive/ thumb drive in and boot up if you get a dos prompt saying O/S not found then your computer will boot to an external drive. We have HP DC5100's and the new Dell's also do this.
What I have done is use the UBCD which uses BartPE and allot of other freeware programs to make a 80 Gig external USB drive. I use it for things like nonbootable systems, for reimaging and spyware, virus scanning and other things.
If you go to ubcd website and read about making the cd it also talks about how to install it on an external drive.
Off topic I have another drive with portable office on it. I can plug it into any computer and use open office and surf the web with out leaving any thing on the computer I am using.

by cefiro2266

I had try using thumb drive and it was able to boot from thumb drive (DOS prompt). But I didn't try using Windows booting.

I didn't use BartPE, what I did was putting this external hd into primary bay (become main hd) and installing windows into it, install whatever programs I want. After completing, I took it out and make it as external hd. But I try to boot from this hd, it fail.

Anything extra need to be done to boot from external hd (only 40gb).

by cefiro2266

As I mentioned before, when I swap this external hd to be the primary hd (put inside the primary bay of the notebook) it is bootable and working well.

BTW, any extra steps involve to "properly configured" external hd as compared to main hd?

by nicknielsen

but check the manufacturer's documentation.

If it works inside, it should work outside. The difference is most likely in the drive case you are using. If you are not using a drive case, check the cables. Also check the notebook manufacturer's documents. There may be something in there about external USB.

Afterthought: Have you tried interrupting the boot sequence to specify the external drive as the boot device?

This discussion is closed to new replies.