Question Locked

Will an IDE primary slave port go bad?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it possible for an IDE primary slave port to go bad? The primary master and both secondary master and slave connections work fine. I try to connect a slave hdd to the primary slave cable and it gives me an 'unknown device' in the bios. Tried all different configurations with jumpers and various hdds.???? WindowsXP SP2 Dell machine

7 replies

by cg it

goes bad, then both HDDs would not be seen.

make sure the pin 1 on the cable is connecting to pin one on the HDD

If one of the pin connectors on the data cable is bad, then that would cause your problem.

If one of the pins on the HDD itself is bent or broken, that wight cause your problem.

Have you tried a different cable? have you tried the HDD in another computer to see if the problem follows the HDD?

by boone999

Yes, tried both of those scenarios.
Gave up - just installed new hdd and used W/D's tool to copy everything over.

Thanks for replying.

by nsteinme

i have the exact same problem. i just ordered a new cmos battery so we will see if that solves it for me.

by computercookie

can you connect the HDD to your secondary ATA cable as a slave or primary?

by boone999

Recognizes it on the secondary primary - did not try the slave.
Gave up - just installed new hdd and used W/D tool to copy everything over.

by thechas

Inspect the IDE connector on the motherboard. You are looking for bent or missing pins.

Only the keying pin should be missing.

While there are failure modes that could cause an IDE port to only be able to access the master drive, the chance is pretty rare.

Chas

This discussion is closed to new replies.