Windows Forum

Ask something
Discussion Locked

Windows 2000Pro and Novell's Rconsole

0 helpful
7 replies

by timber 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running Windows 2KPro on a Dell Latitude. I have SP1 installed Novell Client for Netware 4.8.
When I try to run Rconsole 80% of the time I don't get any servers returned in my list. I have to keep hitting esc and selecting no to reload the server list. I will eventually get a partial listing or a full listing if I'm persistent enough.

I've searched Novell's site and also Technet but I haven't been able to find anything yet. Any ideas????

Thanks
Timber@choice.net

7 replies

by jweber

nw 4.11 using ipx or ip? Both?
if both, what binding order? binding order is based on the client, not the server.

either way, with the NW client, if you'd open the network properties, then advanced, then advanced again, then Provider Order, you can move the netware up the list.
I know that this helps a lot with the unc and mapped drive speed.
YMMV

by timber

That was my initial thought. The binding order is ipx then ip. The netware servers are ipx only however the workstations are IP and IPX. I think I'm going to just format and reload everything. I'm getting tired of messing with it.

Thanks.....

by timber

I'm going to leave this open till tommorow then I'm going to have the time to format and rebuild my system. If I still have the problem after that I'll repost with more points. Thanks giving it a shot!.!.

This discussion is closed to new replies.