Question Locked

Windows 2K Embedded Drive size limits.

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Working on a Pelco 8000 running win2K embedded. Currently the setup supports drives of up to 500GB in IDE flavor.

The MB in the unit is the ASUS P4PE-X and has been flashed to the most recent Bios. In the BIOS screen the drives are properly listed.

Pelco claims that their software will recognize drives up to 750 without a problem.

When I exit out of the Pelco shell into a Win2K desktop I can enter Control Panel - Administrative tools - Computer management - Disk management where the drives are listed. However I cannot partition or format them there.

Am I running up against a limit in the Win2K embedded OS or is this more likely to be a hardware issue? Thanks.

3 replies

by oh smeg

You are using 500 GIG IDE HDD with a ASUS P4PE-X M'Board. Is that correct?

If it is I think you'll find that the BIOS of these M'Boards doesn't support anything near that size natively. I seem to remember that they can use a 150 GIG HDD maybe but nothing bigger.

The 3 of them that I have running here only have 80 GIG HDD's and most of those systems where originally sold with 20 or 40 GIG HDD's.

Col

by ackray

They are running 500 and 350 gig hard drives on IDE Ch1 and for expansion the board can run some 350's we have but we'd like to upgrade to the 750's.

This discussion is closed to new replies.