Question Locked

Windows '98 boot problem

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

In have a PC connected to a CNC machine.
I have recently formatted it and installed Windows 98 on it using the setup copied on the hard disk. Currently, the system boots only from the Floppy Disk although the boot sequence is HDD0 first and then diskette.
How can I fix this?

3 replies

by thechas

If what you did was format the hard drive and copy a set of files to the drive, you did not make the hard drive bootable.

Boot up from a Windows 98 startup disk. It MUST be a startup disk and not just a bootable floppy.

At the DOS prompt, run the command
SYS C:

The copies the system files to the root of the C: drive, and sets a flag that the drive is a bootable system disk.

Chas

by brainlesssme

Since the machine was attached to the CNC, it did not have a CD drive so after partioning the hard drive, i made a copy of Win98 on it. Used a bootable disk to boot the machine, after connecting it to the CNC PC. Installed Windows 98, & at the end of the installation made a start up disk. Although I made changes in the BIOS, but the machine would never boot from the harddrive.

I made changes to Autoexec.bat. Added the "REM" command to every line & now it works fine!!!:)

Thank you.

This discussion is closed to new replies.