Question Locked

Windows Server 2000 not able to browse to all Client Computers

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Need some ideas how to solve this problem. I am running Windows Server 2000 and have about 13 XP Pro workstations attached with static ip addresses. When I go to one of my workstations and browse to my network places/entire network I only see 6 of my workstations and not the rest. I have DNS running and all my forward lookup zones show all my workstations. I have looked at the master browser and it is pointing at my server.

I also see this same problem when I try to do a remote install to my client computers with Symantec Corp Edition 10.1. In fact Symantec is showing an error that some of the workstations need to upgrade to windows 2000 or higher and will not install. Not sure if this is related?

Thanks for your help, Tom.

5 replies

by hal 9000

To connect the computers above the standard 5 workstations and server to the server?

If not find out what is being used Terminal Services or CAL's and buy the extra 2 X 5 pack of Licenses and I think that your problem will disappear immediately. It may be worth while to actually purchase 1 X 20 Pack of Licenses as the 20 pack is only slightly more expensive than the 2 X 5 Packs that you require so you will have some room to grow at very little extra expense. If you add 1 additional computer to the system you'll need another 5 Pack License Set and these are quite expensive.

With Windows Sever products you have a limited number of concurrent connections allowed without additional Licenses so once the server has mapped 5 workstations it's unable to map any remaining workstations because there are not sufficient Licenses available for it to do so.

Col

by thomas.r.lannin

You are right I currently have 10 licenses the server has mapped 10 workstations it's unable to map any remaining workstations because there are not sufficient Licenses available.

Do you have any ideas on how to fix the Symantec Corp Edition 10.1 remote installation? I seem to have the same problem with Symantec Ghost Corp Ed. 8.0. Ghost does not seem to see all my workstations attached. Thanks.

by hal 9000

Turn off the excess workstations and try installing the software.

It's possible that because you lack the required licenses the Symantec Product is picking up the error message from Windows Server and not allowing to be installed.

Col

by thomas.r.lannin

I still think it is a netbios problem or a local security policy stopping the workstation from seeing themselves and the server from see the workstation. I have increased my CAl to 20. The problem is not a licensing issue or I would see more than the 6 workstations on the network. Anyway when I remove all of them but one. The single workstation never shows up either. The workstation can not see itself nor can the Server see the single workstation. Help.

This discussion is closed to new replies.