Question Locked

Windows Server 2003 Installation problems

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am having trouble installing Windows Server 2003. In the middle of copying files certain files come up as "unable to copy" and it offers to let me "try again" or "skip it" or "quit". The first few times I quit and reran the installation but I get no further and the same files come up every time. So now in the process of running the recovery console I explored the CD and found the files are there but the extensions all end with an _ (underscore)example Wingding.ttf is on the CD as wingding.tt_. Can I copy these files to the appropriate location on the machine using the recovery console of do they have to be "installed" by by some process. it was 5 files at first then when the install hit 84% every file was coming up like this.

3 replies

by thumbsup2

Sounds like the CD is either dirty or damaged and can't be read. Fingerprints can sometimes make it totally unreadable. It may also be that the CD ROM itself needs cleaning so that it's eye can see.

With all of the file missing file problems you've encountered, I'd start over. You'll only have problems down the line anyway. Clean the CD and the drive, then try again.

The files ending with _ (ie: tt_) are specially compressed versions of the file to be extracted by the setup routine. Even copying them to the hard drive into the appropriate locations and renaming them (.tt_ becomes .ttf, etc...) wouldn't actually "extract" the compressed file. No, you need to run setup.

---

by ashij

I totally agree with ThumbsUp2, but just adding to it..
IF you want to manually copy these files to the system folder, then you can use the expand command:

[b]Expand[/b]
[u]syntax:[/u]
expand source [/F:filespec}] [destination] [/d] [/y]

[u]Parameters[/u]

source
Specifies the file to expand. Use this if the source file contains a single file. Source can consist of a drive letter and a colon, a directory name, a file name, or a combination. You cannot use wildcard characters.

/f:filespec
If the source contains more than one file, this specifies the name of the file you want to extract. You can use wildcards for the files you want to extract.

destination
Specifies both the destination directory and file name for the extracted file, or each individually.

/d
Lists the files contained in the cabinet file without expanding it or extracting from it.

/y
Suppresses the overwrite prompt when expanding or extracting files.

[u]Example:[/u]
expand d:\i386\acces.cp_ c:\Windows\system32\access.cpl

Ash

This discussion is closed to new replies.