Question Locked

Windows Vista Upgrade and Trouble Shooting

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently upgraded my HP Pavilion (zd8000) laptop to Windows Vista. When I was finished, the first issue I am having is a constant chkdsk whenever the computer is started. The second issue I am having is that the computer will not operate on the batter power alone. In the tray on the menu bar, the computer shows that the battery is 100% but if I unplug the battery, the computer turns off and will not start unless on AC power.

HELP!

7 replies

by oh smeg

Any sensible person would avoid a System still under construction like the plague as there are heaps of problems included with it as you have found out.

As Vista Drivers are not XP Drivers you need to get all new drivers that will not be on the Install Media. Until you have managed to replace every driver the system is very unlikely to work correctly.

Col

by boxfiddler Hot topic

"but if I unplug the battery, the computer turns off and will not start unless on AC power."

If you unplug the battery you have to plug in the AC to provide power?

by jmcnair

Yes, if I remove the AC power, the battery will not power the computer.

by oh smeg

Is either flat or isn't charging and maybe it's shot.

Have you checked the battery for power with a multimeter? Odds are that it doesn't have any power available.

Col

by alpha-male

Does your machine instantly power off....or run briefly then act as if the battery is discharged?

I am facing a similar situation on my HP laptop. The battery charged and worked perfectly under XP - the day I "upgraded" (cough cough) to Vista it no longer seemed to work correctly. I would say I used to get about 2 hours battery life and now get about 5 minutes (at best). The battery shows 100%, but discharges very quickly. I had a spare (new) battery and swapped it into the system...and it displayed the exact same behavior.

I was of the impression that I had somehow damaged the solder joints on the adapter's plug to the motherboard and was deciding to fix or replace. This is a very VERY common problem unfortunately...but it can be repaired.

Still, if you are seeing the same thing, it does beg the question that it may be something to do with the system not reading or using the battery correctly. That's certainly not what I initally thought....but I may test the theory over the weekend.

Interestingly I tried charging/running it in safe mode and it lasted much longer. I thought that was odd...but considered it perhaps a fluke at the time (maybe I had the cable just situated right and got a better connection/charge).

Another possibility si to charge a battery in a different system and see if it works/lasts longer. I don't have one available, so I haven't been able to try that. I also thought that perhaps using a dock connected to the AC adapter would work around the issue effectively.

Anyone have any thoughts on these ideas?

by frio80

It says on the HP website that the zd8000 is vista non-compatible. I have the ZD8000 and am trying to load vista as well but am running into a slew of errors. Where are you getting the drivers from since HP is not supplying them? Did you get an error message when installing saying "Windows cannot run on this hardware..." Thanks.

This discussion is closed to new replies.