6 replies
by stingray1527 Accepted solution
by churdoo Accepted solution
by thechas Accepted solution
First, you likely cannot see your drives from the boot disk as you are booting to DOS and DOS cannot read NTFS format drives. You can get NTFS reader software. Or, install the drive as a slave or external drive on another XP system.
As to recovering your system, you do not want the recovery console. You want to follow the normal install process, select the existing folder for the installation, and when prompted, choose repair rather than a new installation.
Even if you end up performing a clean install of XP, your data files will be intact. The clean new registry however will not know that any of your application software exists.
Chas
by stingray1527 Accepted solution
by churdoo Accepted solution
... but I think this is what you're looking for,
http://support.microsoft.com/kb/307545
except that instead of booting to recovery console, this is with the drive slaved in your second machine; substitute the drive letter assigned to the slaved drive in the manual directions of this article. Also, do this from a CMD prompt rather than being tempted to use winders explorer.
by sleepin'dawg Accepted solution
I would suggest trying that first and then hopfully you could use a previous "Restore" point.
The slave idea is a good one but trying safe mode first is simpler and less likely to corrupt anything else. BTW you may be missing or have corrupted more than the above mentioned file so restoring to a a known restore point is a lot easier than searching for corrupted files.
If you can't boot in safe mode then go the slave route.
I would also suggest purchasing a UPS if the "improper shutdown" was the result of a power failure. They're not all that expensive anymore.
[b]Dawg[/b] ]:)
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending